Features
- 6 x Selectable control modes:
- 1 x 0% lock mode
- 4 x user-defined modes
- 1 x 100% lock mode
- Control modes can be selected using the dash mounted ACD button.
- Each mode is configurable with an acceleration table, braking table and desired slip table.
- The percentage lock can be configured using vehicle speed and throttle position. With the MoTeC Plug-InĀ ECUĀ connected, engine efficiency point can be used instead of throttle position. The ECU will calculate and then send the efficiency point to theĀ MDC. This feature uses the factory wiring loom.
- With theĀ RS232Ā serial communications configured, the MDC can send wheel speeds, lateral G-force, longitudinal G-force, steering position, diff parameter and fault codes to the MoTeCĀ M800Ā Plug-In ECU without the need for additional sensors.
- TheĀ CANĀ interface optionally transmits the sensor and diagnostic information to a MoTeC Dash Logger.
- Handbrake override.
Specifications
Communications
- 1 xĀ CAN
- 1 x RS232
Physical
- Connector
2 x Connectors fitting directly into factory wiring- 1 x 26 pin
- 1 x 22 pin
- Case size
111 x 83 x 31 mm, excluding mounts